Configuring the Base Station is part of the initial setup of a job site. Since the base location is the reference that all measurements are based on, setting it up so it remains a constant is critical.

The Initial flow is this:

Set from GPS - Starts GPS collection of positions for 10 shots and updates the Lat/Long/Height display. Takes the median position and displays it as the final value. During the shots a progress bar shows the shots being taken as feedback.

Set from File

Lat/Long/Height - The read out from the GPS or file

Satellites - The number of satellites visible to the base. This is more for feedback about potential base issues.

Device - The current device chosen. Most of the time this stays the same and is remembered between sessions.

Configure - Allows setting of device type, configuration and radios

Logo - Enable Link to the AGTEK website when tapped?