This is a live document for testing SmartGrade RTK. Because there are so many different paths my best guess is that we organize this in test modules that we can add to and refine over time. ===== Alignment ===== == Standard Shoot two Benchmarks == Over extended distance Repeatability of Cell based GPS (nearest and Imax) == Reshooting Benchmark 2 == == Reshooting Benchmark 1 == === Importing Recover === === Manually entered NE BM === === BM entered via picking on Job === ==== Cell Alignment ==== ===== GPS Instruments ===== ==== Cell Devices ==== === Topcon Cell (GR-3) === === Altus === === Leica === ==== Base/Rover ==== === Topcon === === Altus === ===== Grade Mode ===== ===== Stake Mode ===== ===== New Survey ===== ===== New Measure ===== ==== New Measure from File screen ==== - Start New Measure - Shoot Base - Shoot Benchmarks - Save - Remove Shots - Stream Data - Take Picture - Shoot Manual shots - Check Elevation, Distance, and Total values - Panning works correctly ===== Progress Topo ===== Progress topo may be the most complicated part of SmartGrade. Here are some scenarios and their variations ==== Existing Ground - No Design - Shoot Survey ==== ==== Existing Ground - Design - Shoot Survey ==== === Existing Ground - No Design - Shoot 2nd Survey Compare to 1st survey, Existing, Design === ==== Existing Ground - No Design - Shoot Survey ==== ==== New Survey ==== - Shoot new Survey - Progress Topo - Enter boundary, view 3D surface - Make Surface - Switch to Grade and survey against new surface ==== New Survey - Add another Surface ==== - Open New Surface file - Shoot new survey - Progress Topo - Enter boundary, compare volumes ==== New Survey - Add to a surface via Stage (forms new surface) ==== ===== Saving ===== This may also be in parts of other test modules. List of all Save types done * ADF * AGT * Save As * KMZ * KMZ Stockpile with model * LLA * GPX recording (GPS sim) Uploading